HomeProductsBrochuresFactory ContactsRequest LiteratureRep LocatorRequest for Quote

BLOWOFF TANKS
Traditional Style Blowoff Tank Sized to National Board

Blowoff Tanks

Blowoff Tanks

Penn Blowoff tanks come standard ASME Code Sec. VIII, Div.1 designed and stamped for 50 psig at 450 deg. F. and are of a welded construction from 3/8" thick carbon steel materials. A blowdown tangential inlet with stainless steel wear plate, water overflow outlet which extends to within 6" of the bottom of the tank, a 3/4" siphon shall be located in the top portion of the outlet pipe and atmospheric steam vent. The tank would be supported by a set of four angle legs with floor pads. 36" diameter and smaller tanks include couplings for inspection ports and larger tanks include a manway. A level gauge, thermometer, and pressure gauge can also be supplied as an option.

 

NATIONAL BOARD BOILER BLOWOFF EQUIPMENT RULES 1991 EDITION

The blowdown from a boiler(s) that enters a sanitary sewer or discharges in an area which could be hazardous to life or property should be controlled. The control should be through some form of blowoff equipment which will reduce the pressure and temperature to acceptable safe levels.

 

 

Blowoff Tanks

CLICK HERE FOR TANK SIZING

Penn Blowoff Tanks are completely welded and assembled in Brookville, Pennsylvania, USA using only new materials with a shop primer applied to the exterior. Each unit is skidded for shipment and carries a full year warranty against materials and workmanship.

 

PENN SEPARATOR CORPORATION
5 South Pickering
P.O. BOX 340
Brookville, PA 15825
(814) 849-7328
Fax: (814) 849-4510
TOLL FREE: 1-888-PENN-SEP (7366-737)


Designed by OnTech
OnTech