BLOWDOWN SEPARATOR PACKAGE

Suggested Specifications

BLOWDOWN SEPARATOR:

Furnish and install as shown on plans:
( ) Boiler Blow-Down Separator(s). Model No. A _____ w/a _____" Inlet _____" Drain_____" Vent As Selected from Selector Chart for a Boiler Operating at _____ psig. With a _____" Intermittent Blowdown Valve

The separator is to be 14" Diameter (Except A14 Model is 10.75" Diameter) and a Welded Carbon Steel Vessel Designed and "UM" Stamped to ASME Code for 250 psig @ 450 Deg. F. Select a Plate Thickness (5/16',or 3/8'), and Add for National Board "U" Stamp as Required for Location of installation. Flanged units are limited to pressure rating of the flanges and would be stamped accordingly.

Connection are available in (Threaded, Weld Bevel, or Flanged) type Include a Tangential Inlet with Stainless Steel Striking Plate at point of impingement, a Centrally Located Steam Vent for clean quite release of steam to atmosphere, and Bottom Drain fitted with a Stainless Steel Spiral Baffle. The exterior to be a shop primer finish. All as manufactured by the Penn Separator Corp., Brookville, PA., USA.

Separator Accessories

Furnish and install the Penn Separator W/3 Angle Legs for Floor
Mounting ( ) or Wall Mounting Brackets ( ).
AND
Furnish and install as shown on plans for Manual Cooling of Drain Water Temperature Penn Separator Aftercooler Model A5D-_____" w/ _____" C.W.I (cold water inlet)
OR
Furnish and install as shown on plans for Automatic Control of Drain Water Temperature to 140 Deg. F. A Automatic Aftercooler Fitting Model (18DF-_____", 16DS-_____", or 20AO-_____") w/_____" C.W.I., a Temperature Regulator Vlave sized for cooling water at (40, 50, or 60) psig. Include a Pressure Reducing Valve if required to limit cooling water pressure to a maximum 60 psig, Strainer, and 2" Dial Bimetal Thermometer. Optional Accessories could include a Pressure Gauge w/Siphon, Cooling Water Line Ball Cone Check Valve, or Vent Line Exhaust Head.